Comelit MT 49804 - Manual (Page 30)

User’s Manual
20
NOTE: Do NOT use the same port number for two different programs, otherwise, the DVR
cannot be connected with the PC running RAS or WebGuard.
CAUTION: When changing the port settings, you must change the port settings on
the PC running RAS or WebGuard as well. Refer to the RAS manual for details.
NOTE: Entering the ID and Password and highlighting OK reads the current IP address
of the DVR configured by the ADSL network.
NOTE: If the DVR is configured for DHCP or an ADSL network, the IP address of the DVR
might change whenever the unit is turned on.
Highlight the DVRNS tab, and the DVRNS setup screen displays.
Selecting DHCP from the Type and highlighting
Save button reads the current IP address of the
DVR configured by DHCP (Dynamic Host
Configuration Protocol) network.
Highlight Auto and press the button to
toggle between On and Off. When it is On,
the DVR will obtain the IP address of the
DNS server automatically.
NOTE: Selecting Auto will only be enabled
when the DVR is configured for DHCP
network.
Selecting ADSL (with PPPoE) allows you to
set up the ADSL network.
Highlight the box beside ID and press the
button. A virtual keyboard appears allowing you
to enter the ID for ADSL connection.
Highlight the box beside Password and press
the button. A virtual keyboard appears
allowing you to enter the password for ADSL
connection.