Comelit MT 49804 - Manual (Page 41)

Digital Video Recorder art. 49804
31
Highlight the Actions tab, and the Motion Detection Actions setup screen appears.
NOTE: For the Record action, the camera you select should be set to the Event or Time
& Event recording mode in the Record Schedule setup screen.
Highlight the box under the Notify heading and press the button. You can toggle the entire list
On and Off by highlighting Notification and pressing the button. You can toggle the individual
items On and Off by highlighting that item and pressing the button. Highlight OK and press
the button to accept your changes.
NOTE: For the Notify action, the notify item you select should be enabled in the Notification
setup screen and the DVR should be registered in the RAS (Remote Administration System).
Video Loss
Highlight Video Loss in the Event menu and press the button. The Video Loss setup screen
appears.
Highlight the box beside Daytime and press the button. Use the
Up and Down arrow buttons to set the Daytime range. The DVR will
consider the remaining time range as the Nighttime.
Figure 35 ņ Motion Detection Actions setup screen
The DVR can be set to react to motion detection
differently for each camera. Each camera can
be associated with another camera, and/or notify
a number of different devices.
NOTE: You can associate multiple cameras
with a camera that detects motion.
Highlight the box under the Record heading and
press the
button. A list of cameras appears.
You can associate as many cameras with that
camera as you wish. If the DVR detects motion
on the selected camera, it starts recording video
from all the associated cameras.
Figure 36 ņ Video Loss Settings setup screen.
Highlighting the box under the Video Loss
Interval heading allows you to set the duration
of a signal loss before the DVR will report a
Video Loss. The DVR will not consider any
signal loss from a camera to be a Video Loss
if the detected signal loss is shorter than the
interval set on this screen.