Comelit MT 49804 - Manual (Page 40)

User’s Manual
30
You can define the area of the image where you want to detect motion; e.g., a doorway. Highlight
the box under the Zone heading, and press the button. The Motion Detection Zone screen
displays.
Press the button to display the menu screen. The menu on the setup screen has the following
functions:
Turning Zone View On will allow you to observe how the DVR is reacting to motion. When in
the
motion viewing mode, any detected motion within the zone will be displayed in red.
You can control excessive event logging and remote notification of motions detected after the
motion dwell time by adjusting the motion ignoring dwell intervals. Highlight the box beside
Motion Ignoring Interval and press the button. A list of intervals ranging from 1 to 5 seconds
or Never appears. The
DVR will not log and notify motion events occurred during the preset
interval range.
NOTE: The record action for motion events will not be affected by the Motion Ignoring
function.
Highlighting the Daytime Setup… box and pressing the button allow you to set up the Daytime
range.
Highlighting the box under the Sensitivity heading and pressing the
button allows you to adjust the DVR’s sensitivity to motion for
Daytime and Nighttime independently. There are five settings with
1 being the least sensitive and 5 being the most sensitive.
The Motion Detection Zone screen is laid over the video for
the selected camera. You can set up motion detection zones
by selecting or clearing blocks.
NOTE: You can set up motion zones one block at a time
in groups of 3 individual block groups. A block group is
positioned within the image area using the Up and Down
arrow buttons, and individual blocks within the block
groups are selected or cleared using the camera buttons.
Select ņ Activates highlighted blocks to detect motion.
Clear ņ Deactivates highlighted blocks so that they will not detect motion.
Reverse ņ Activates inactive highlighted blocks and deactivates active highlighted blocks.
Select All ņ Activates all blocks to detect motion.
Clear All ņ Deactivates all blocks so that they will not detect motion.
Reverse All ņ Activates inactive blocks and deactivates active blocks.
OK ņ Accepts changes and closes Zone setup.
Cancel ņ Exits Zone setup without saving changes.
You can adjust the minimum number of detection blocks that must
be activated to trigger a motion alarm. Highlighting the box under
the Min. Blocks heading and pressing the button allows you to
adjust the minimum number of detection blocks for Daytime and
Nighttime independently. Smaller numbers provide greater sensitivity
because fewer detection blocks must be activated.