Comelit MT 49804 - Manual (Page 32)

User’s Manual
22
Figure 21 ņ RTSP setup screen.
Highlight Enable RTSP (Real-Time
Streaming Protocol) and press the button to
toggle between On and Off. You will be able
to change the settings if Enable RTSP is
enabled.
NOTE: When selecting Enable RTSP, the
recorded image resolution cannot be set to
Very High during Record setup.
Highlight the box beside RTSP Port and press
the button. Set the port number of the RTSP
server obtained from your system administrator.
Highlight the box beside RTP Start Port and press the button. Set the start port number of
the RTP server obtained from your system administrator.
Highlight the box beside RTP End Port and press the button. Set the end port number of the
RTP server obtained from your system administrator.
Highlight Use Mobile and press the button to toggle between On and Off. When set to on, you
can access a remote DVR using a Blackberry or other mobile devices.
NOTE: Selecting Use Mobile sets the recorded image resolution to Standard automatically
regardless of your Record settings.
NOTE: Selecting Use Mobile sets the remote watch quality to Basic automatically regardless
of your Network – Remote Watch settings.
NOTE: Selecting Use Mobile sets the WebGuard service to be enabled automatically
regardless of your WebGuard settings.
NOTE: You can access a remote DVR and monitor live video images using media players,
such as VLC Player, supporting RTSP service. Start the media player on your local PC
and enter “rtsp://ID:Password@IP address:RTSP port number/‘channel number’”, or start
Internet Explorer on your Blackberry or other mobile devices and enter “http://IP address:
Webguard port number/”.
NOTE: RTSP service might not be supported, depending on the type of media player.
Highlight the WebGuard tab, and the WebGuard setup screen displays.