INFICON Protec P3000(XL) Helium Leak Detector - Manual (Page 22)

1-12
General Information
k
in
a
26
e Ch
ap
te
r
1
.fm
Tech
ni
ca
l Ha
nd
bo
ook
(1
20
9)
1.6 Installation
1.6.1 Set up
How to remove the transportation lock:
The transportation lock is located on the bottom side of the Protec P3000 and
consists of a yellow knurled screws. Please remove this screw before starting-up the
leak detector. The Protec P3000 is supplied ready for operation. Initial start-up is
described in Section
3.1 .
Fig. 1-3 Removing the transportation lock before starting
Caution
Before installation remove the transportation lock.
Caution
In order to ensure adequate ventilation of the Protec P3000, a space of at least
20 cm 8) (8 in.) must be kept unobstructed to the sides. The clearance at the rear
must be no less than 10 cm (4 in.). Moreover, the Protec P3000 handles for carrying
the leak detector at the sides of the main unit must not be covered at any time as
these acts as air inlet and outlet. Avoid the presence of heat sources in the vicinity
of the Protec P3000.