Lenze PC-based Automation Industrial PC - Manual (Page 12)

Industrial PC | Parameter setting & configuration
About this documentation
Document history
12
L
2.5 EN - 01/2012
1.1 Document history

Tip!
Current documentation and software updates on Lenze products can be found on
the Internet in the "Services & Downloads" area under:
http://www.Lenze.com
Version Description
1.0 07/2007 TD16 First edition control technology 1.0
1.5 11/2007 TD16 Updated parameter lists control technology 1.5, amended by the »WebConfig«
2.0 05/2008 TD11 Control technology 2.0, amended by the parameter lists for the MC-CAN2, MC-ETH,
and
MC-ETC communication cards.
2.1 08/2008 TD11 Control technology 2.1, "(in preparation!)" removed for Release EtherCAT,
Update EtherCAT parameters.
2.2 05/2009 TD11 Control technology 2.2, update for the new software version
• Update of the German »WebConfig« user interface,
• Added default settings of IP addresses,
• Amended by the IP port in the system overviews,
• Added contents from system verification,
• Added ID numbers to document,
• Amended by the parameter list of the MC-PBM communication card.
2.3 11/2009 TD11 Control technology 2.2.2, update for the new software version
• new chapter: Lenze specifications - exception handling
• new chapter: Configuration of the OPC tunnel
2.4 01/2011 TD11 Control technology 2.5, update for the new software version
2.5 01/2012 TD11 Control technology 2.6, update for the new software version