4 representation of the parameters, 1 parameters with read access, 2 parameters with write access – Lenze PC-based Automation Industrial PC User Manual
Page 42: 1 parameters with a setting range, 2 parameters with a selection list, Parameters with a setting range, Parameters with a selection list, Industrial pc | parameter setting & configuration
Industrial PC | Parameter setting & configuration
Parameterisation using the L-force »Engineer«
Representation of the parameters
42
L
2.5 EN - 01/2012
6.4
Representation of the parameters
6.4.1
Parameters with read access
The »Engineer« displays the parameters with read access with a grey background or,
when an online connection has been established, with a pale yellow background:
6.4.2
Parameters with write access
Input values outside the valid setting range are represented in red font by the
»Engineer«.
6.4.2.1
Parameters with a setting range
In the »Engineer« parameters are set by entering the desired value into the input field
or by means of the two arrow buttons:
The two arrow buttons can be used to increase/decrease the displayed value stepwise.
6.4.2.2
Parameters with a selection list
In the »Engineer« the parameters can be changed via a selection list: