Lenze PC-based Automation Industrial PC - Manual (Page 19)

2.5 EN - 01/2012
L
19
Industrial PC | Parameter setting & configuration
Commissioning
4 Commissioning
This chapter provides general information on the first commissioning of an Industrial PC.
Depending on the actual hardware installed, different settings are required to integrate
the Industrial PC for machine control purposes into a network.
Further information on the setting of the IP address of your Industrial PC can be found in
the following section:  Entering the IP address of the Industrial PC
( 32)

Note!
• Please observe the following predefined IP addresses when commissioning
your IPC for the first time:
– Engineering PC: 192.168.5.100
– Industrial PC: 192.168.5.99

Read the Mounting Instructions accompanying the controller first before you start
working!
The Mounting Instructions contain safety instructions which must be observed!

Further information on the device-specific properties can be found in the
Hardware Manual of the corresponding Industrial PC.