Metal Sales Clip-Loc Installation - Manual (Page 27)

CLIP-LOC
© Metal Sales Manufacturing Corporation/ Subject to change without notice/ Effective Date 2/03
812.246.1935 (Corporate Offi ce) • www.mtlsales.us.com
26
V
ALLEY
O
VER
D
ECKING
(F
IXED
)
6" Minimum
All Valley flashings must be installed prior to panel installation. If two or more valley flashings are required, valley must
be installed working from eave to peak. It is recommended that ice and water shield be installed under valley flashing for
added moisture protection.
1. Install Valley flashing against substrate. To hold Valley flashing in place, fasten to substrate with #10-12 x 1" Pancake Head
fastener 4'-0"o.c.
2. Apply a row of Double Bead Tape Sealant across both sides of Valley flashing approximately 5" from center of valley.
3. Properly align and install Clip-Loc Inside Valley Closures to accommodate Clip-Loc panel rib alignment. Closures are
designated "Left" or "Right". Closures must be installed on both sides of valley flashing and lined up with panel ribs for proper
seal. Do not apply tape sealant on top of closure.
4. If two or more flashings are required, lap the flashing over the previously installed flashing by a minimum of 6" placing two
beads of tube sealant per side between the flashings.
5. Once panels have been installed, (see pages 21-22), fasten through panel, closure, and sealant into substructure with 6 fasteners
per panel. Fasteners must penetrate closure and sealant to eliminate closure movement.
Double Bead Tape Sealant
Clip-Loc Inside Valley Closure
Clip-Loc Panel
Clip-Loc Clip
Moisture Barrier (by others)
#9-15 x 1 1 /
2
" Woodscrew (Optional)
(see below)
Valley
CAUTION
Additional screws
may be required for
high snow loading
and steep slopes.
1:12 Slope
Minimum
INSTALLATION NOTES
Clip-Loc Fastening Pattern
#9-15 x 1 1 / 2 " Woodscrew
XL (6) per panel