Metal Sales Clip-Loc Installation - Manual (Page 49)

CLIP-LOC
© Metal Sales Manufacturing Corporation/ Subject to change without notice/ Effective Date 2/03
812.246.1935 (Corporate Offi ce) • www.mtlsales.us.com
48
G
UTTER
O
VER
O
PEN
F
RAMING
All gutter flashings must be installed prior to panel installation.
1. Install Box Gutter flashing back against eave strut. To hold Box Gutter flashing in place fasten to substrate with #10-16 x 1"
Pancake Head Driller at 4'-0" o.c.
2. Install Universal Gutter/Downspout Straps every 3'-0" of gutter length. Before continuing make sure strap placement is such that
strap can be fastened to eave strut with panel fasteners. See note #6. Pop Rivet Universal Gutter/Downspout Strap to Box Gutter.
3. Apply a row of Double Bead Tape Sealant across Box Gutter flashing approximately 2" from backside of gutter flashing.
4. Properly align and install Clip-Loc Inside Closures to accommodate Clip-Loc panel rib alignment. Closures must be lined up
with panel ribs for proper seal. Do not apply tape sealant on top of closure.
5. If two or more flashings are required, lap the flashing over the previously installed flashing by a minimum of 2" placing a bead
of tube sealant between the flashings and securing with pop rivets 2
1 /
2
" o.c.
6. Once panels have been installed, (see pages 44-45), fasten through panel, closure, and sealant into eave strut with 6 fasteners per
panel. Before continuing make sure at least one fastener secures Universal Gutter/Downspout Strap to substrate. Fasteners must
penetrate closure and sealant to eliminate closure movement.
Universal Gutter/ Downspout Strap (3'-0" o.c.)
Double Bead Tape Sealant
Box Gutter
Clip-Loc Inside Closure
Pop Rivet (every strap)
#12-14 x 1 1 /
2
" SD XL
(6) per panel (see below)
CAUTION
In locations where heavy
rainfall or severe ice and
snow may occur, Metal
Sales' standard gutters may
not be suitable for use.
0"-1
1 / 2
"
1:12 Slope
Minimum
INSTALLATION NOTES
Clip-Loc Fastening Pattern
#12-14 x 1 1 / 2 " SD XL
(6 per panel)