Clip-loc – Metal Sales Clip-Loc Installation User Manual
Page 29
CLIP-LOC
© Metal Sales Manufacturing Corporation/ Subject to change without notice/ Effective Date 2/03
812.246.1935 (Corporate Offi ce) • www.mtlsales.us.com
28
R
AKE
(O
FF
M
ODULE
) O
VER
D
ECKING
Clip-Loc Foating Rake Zee and Clip-Loc panels must be installed prior to rake installation (see pages 21-22).
Panel must be field bent up 1
5
/
8
".
1. Position and install Cleat to wall with appropriate fastener, 1'-0" o.c. Make sure Cleat installation allows for proper Clip-Loc
Rake attachment.
2. Apply a row of Double Bead Tape Sealant between Floating Rake Zee and field bent panel rib. Fasten field bent panel rib to
Clip-Loc Floating Rake Zee with 12-14 x 1½" SD XL 1'-0" o.c.
3. With Clip-Loc panel properly fastened to Clip-Loc Floating Rake Zee, apply a row of Double Bead Tape Sealant across top of
Floating Rake Zee.
4. Install Clip-Loc Rake flashing by sliding open hem onto Cleat and resting the Clip-Loc Rake flashing on top of Floating Rake
Zee. Fasten through Clip-Loc Rake, sealant, and into Clip-Loc Floating Rake Zee with ¼-14 x
7
/
8
" Stitch XL 1'-0" o.c. Stagger
Stitch fastener so that there is no interference with 12-14 x 1½" SD XL already installed.
5. If two or more flashings are required, lap the flashing over the previously installed flashing by a minimum of 2" placing a bead
of tube sealant between the flashings and securing with pop rivets 2
1
/
2
" o.c.
Double Bead Tape Sealant
#
1
/
4
-14 x
7
/
8
" Stitch XL (1'-0" o.c.)
Clip-Loc Panel
Moisture Barrier (by others)
Cleat
#10-12 x 1" PHW (1'-0" o.c.)
Floating Rake Zee
Clip-Loc Rake
12-14 x 1
1
/
4
" Shoulder Tech (1'-0" o.c.)
12-14 x 1
1
/
2
" SD XL (1'-0" o.c.)
Field bend panel rib up 1
5
/
8
"
1:12 Slope
Minimum
INSTALLATION NOTES