MTS Criterion 40 - Manual - Manual (Page 114)

MTS Criterion ® Series 40 Product Manual 114
Handset Control
Operation
Handset Control
The handset has an encoder and buttons to help you during specimen installation
and test execution. The handset also has an alphanumeric display and LEDs to
provide feedback.
Handset functions
The handset is intended to be used for specimen loading or setup. In some
applications, it can be used to completely run a test.
Handset Controls and Indicators (part 1 of 2)
# C ONTROL /I NDICATOR D ESCRIPTION
1 Page Displays the next four lines of text in the display.
2 Active When lit, indicates the system is active (motion is possible).
3 F1 and F2 Programmable functions that are set up in the software as digital
inputs. This allows you to define the test function (that is, start test,
pause, hold position, and so forth).
4 Thumb-wheel Makes fine crosshead adjustment (towards display – up; away from
display – down. Only if Handset Enable is active.
5 Pause Pauses the test action. This must be pressed again for the test to
resume. Only if the testing software is active.
6 Stop Stops motion.
Criterion_product manual.book Page 114 Monday, July 28, 2014 3:52 PM