MTS Criterion 40 - Manual - Manual (Page 61)

Single-Column Load Frame
MTS Criterion ® Series 40 Product Manual
Installation 61
9. Install the safety switch. Prior to assembling the safety switch mount plate
(Item 6), put the cable of the safety switch (Item 4) along the groove in a
left-ward direction. (The cable is pre-mounted in the slot of the right-side
panel assembly). Using two M6 X 20mm socket head screws and the M6
C'bore butt fasteners, mount the safety switch mount plate to the side panel.
10. Position the safety switch (Item 4) with the arrow-on switch pointing
forward. Using the M4 x 35mm crossed discal screws and M4 washers,
mount the switch to the safety switch mount plate.
11. Place the front door (Item 13) into position and secure the hinges to the left-
side panel’s hinges.
12. Check for proper alignment of the safety switch and adjust as needed.
13. Remove the protective covering from the panels and door.
When the assembly is completed, it should look like the previous figure.
Model C41 Load Frame with Enclosure
Criterion_product manual.book Page 61 Monday, July 28, 2014 3:52 PM