MTS Criterion 40 - Manual - Manual (Page 136)

MTS Criterion ® Series 40 Product Manual 136 Declaration of Conformity
Page 2 of 2 DoC Criterion 40 July 22 2014
Equipment Description:
The MTS CRITERION 40 MATERIAL TESTING SYSTEMS (C41, C42, C43, C44 AND C45) 50 N to 600 kN with
TestWorks Software is intended to perform testing of materials and components, including plastics, metals, composites,
adhesives , textiles, wood and paper products, ceramics, elastomers, and foam.
Includes the following sub-systems of the machine: Frame, Motor, Amplifier, Controller, Handset and Cables.
Customer must evaluate risks due to ejected parts or materials from the test specimens. If Test Area Guard is not
selected by customer, then for protection against ejected parts or materials from test specimens and to control access to
the machinery, the Customer must provide a Test Area Guard to protect personnel.
Manufacturer:
MTS Systems Corporation
14000 Technology Drive
Eden Prairie, MN 55344-2290, U.S.A.
Authorized Representative:
Martin Smaller
MTS Systems Ltd
Brook House, Somerford Court
Somerford Road
Cirencester GL7 1TW
Glos. - UK
Applicable Directive(s):
Machinery Safety Directive 2006/42/EC
Low Voltage Directive 2006/95/EC
EMC Directive 2004/108/EC
Harmonized or Other Standards Referenced:
EN ISO 12100 Safety of machinery – General principles for design – Risk assessment and risk reduction
EN 61010-1: Safety requirements for electrical equipment for measurement, control and laboratory use, Part 1: General
requirements
EN 61326-1: Electrical equipment for measurement, control and laboratory use EMC requirements Part 1: General
requirements
EN 55011 Industrial, scientific and medical (ISM) radio-frequency equipment — Electromagnetic disturbance
characteristics — Limits and methods of measurement
Group 1: class A (non-domestic where RF is NOT used in the treatment of material)
Technical Construction File in accordance with Annex VII Part A:
A copy (electronic and paper) of the Technical Construction File for this machinery is available on request from:
Authorized Representative
We, MTS Systems Corporation, hereby declare that the machinery described above conforms with the relevant
provisions of Annex I Essential Health and Safety Requirements of Directive 2006/42/EC and that the Annex VIII
Conformity Assessment Procedure has been carried out.
Place of Issue:
Eden Prairie, MN 55344, USA
Date of Issue:
Signature:
Name and Title: Grant Ovsak - Vice President (Global Engineering)
Criterion_product manual.book Page 136 Monday, July 28, 2014 3:52 PM