MTS Criterion 40 - Manual - Manual (Page 73)

Installing Cables
MTS Criterion ® Series 40 Product Manual
Installation 73
J5 Digital I/O
The J5 connector routes the Digital I/O from the MTS Insight control board to
J12 on the MTS Criterion interface board. The pin assignment below is only for
reference. The cable from J5 to J12 must be connected for system operation.
J6 and J7 Monitor
Two monitor connectors are provided. There are several possible uses for analog
monitor outputs: external data acquisition, tuning, troubleshooting, and so forth.
For tuning, it is desirable to monitor command and feedback, or command and
error, simultaneously while changing the controller parameters. Therefore, two
monitor outputs are provided. Specifics for these connectors are:
• Analog +/-10.5 V
• Calibrated to +/-10 V
• 16-bit resolution minimum
• BNC connectors
P IN S IGNAL
1 DIN1+
2 DIN2+
3 DIN3+
4 DOUT1+
5 DOUT2+
6 DOUT3+
7 No Contact
8 +12 V
9 DIN1-
10 DIN2-
11 DIN3-
12 DOUT1-
13 DOUT2-
14 DOUT3-
15 Analog GND
Criterion_product manual.book Page 73 Monday, July 28, 2014 3:52 PM