MTS Criterion 40 - Manual - Manual (Page 66)

MTS Criterion ® Series 40 Product Manual 66
Dual-Column Load Frames
Installation
1. Remove the M6 X 20mm socket head screws (Item 3) from the frame.
2. Position the left-side panel assembly (Item 1) on the frame base, and thread
the screws through the holes on the frame.
3. Secure the left-side panel to the frame using four M6X40 mm socked head
screws (Item 10). Do not over-tighten. You can position for alignment after
the right-side panel (Item 9) and horizontal bar (Item 4) are installed.
4. Repeat Steps 2 and 3 for the right-side panel assembly (Item 9).
5. Use the M6 butt fasteners (Item 2) to connect the horizontal bar (Item 4) and
the side panel.
6. When the all of above components are aligned, hand-tighten all fasteners.
7. Install the safety switch. Prior to assembling the safety switch mount plate
(Item 8), put the cable of the safety switch along the groove in a left-ward
direction. (The cable is pre-mounted in the slot of the right-side panel
assembly). Using two M6 X 20mm socket head screws and the M6 C'bore
butt fasteners, mount the safety switch mount plate to the side panel.
8. Position the safety switch (Item 6) with the arrow-on switch pointing
forward. Using the M4 x 35mm crossed discal screws (Item 5) and M4
washers, mount the switch to the safety switch mount plate.
9. Place the front door (Item 11) into position and secure the hinges to the left-
side panel’s hinges.
10. Check for proper alignment of the safety switch and adjust as needed.
Criterion_product manual.book Page 66 Monday, July 28, 2014 3:52 PM