MTS Criterion 40 - Manual - Manual (Page 60)

MTS Criterion ® Series 40 Product Manual 60
Single-Column Load Frame
Installation
1. Cut the slits for the enclosure legs on the rubber mat (Item 9) with a knife.
2. Remove the handset component (Item 8) from the frame, disconnect the
cable with the handset, and remove the aluminum column from the frame.
3. Position the right-side panel assembly (Item 7) on the frame base, and
thread four M6X30 socket head screws (Item 10) through the holes on the
frame.Do not over-tighten. You can position for alignment after the left side
panel (Item 1) and horizontal bar (Item 12) are installed.
4. Put two M6 C'Bore butt fasteners (Item 11) in the slots in the right-side
panel.
5. Position the handset component on the right-side panel assembly (Item 7)
and connect the cable as done previously. Insert two M6X20mm socket head
screws (Item 12) and hand-tighten.
6. Repeat Steps 3 through 5 for the left-side panel assembly (Item 1).
7. Install the rear of the enclosure prior to mounting the lower horizontal bar
(Item 2) in the back of the enclosure with the M6 butt fastener (Item 3).
Then insert the back glass (Item 5) into the slots in the side panel, and install
the remaining two horizontal bars (Item 2) with the M6 butt fastener (Item
3).
8. When all of the above components are aligned, hand-tighten all fasteners.
I TEM D ESCRIPTION
1 Left Side Panel Assembly
2 Horizontal Bar
3 M6 X 20mm Socket Head Screw, M6 Butt Fastener
4 Safety Switch
5 Back Glass
6 Safety Switch Mount Plate
7 Right Side Panel Assembly
8 Handset Component
9 Rubber Mat
10 M6X30mm Socket Head Screw
11 M6 C’bore Butt Fasteners
12 M6X20mm Socket Head Screw
13 Front Door
Criterion_product manual.book Page 60 Monday, July 28, 2014 3:52 PM