MTS Criterion 40 - Manual - Manual (Page 123)

MTS Criterion ® Series 40 Product Manual
Decommissioning 123
Decommissioning
The decommissioning process is performed when the system is going to be
moved or taken out of service. Disassembly is required when performing either
of these tasks.
To decommission the system:
1. Remove specimen and fixtures. Large grips should be removed if the load
frame could be tipped over.
2. Isolate the system from electrical power.
3. When the system electronics, control software, and the system PC are
powered down, turn off the system’s main electrical supply and disconnect
all cables.
4. Disconnect all cables from the controller.
5. Cover the material testing machine with a dust cover, such as plastic foil.
Allow for sufficient ventilation or place a dehumidifier near to the
equipment.
6. Place the accessories and the instruction manual in a clean, dust-protected
place, such as a tool cabinet.
Electrical components and parts can contain hazardous chemicals and
compounds.
These chemicals and compounds can cause environmental
problems. Always refer to local codes that govern the disposal of
potentially hazardous materials and follow these codes for the
proper handling and disposal of these materials.
Follow internal safety policies for safe disposal of parts of the machine. Refer to
MSDS for oils and greases that are used on the machine.
CAUTION
Criterion_product manual.book Page 123 Monday, July 28, 2014 3:52 PM