MTS Criterion 40 - Manual - Manual (Page 72)

MTS Criterion ® Series 40 Product Manual 72
Installing Cables
Installation
J4 Encoder
This connector is intended for encoder-based transducers. Specifics for this
connector are:
• Power: +5 V +/- 0.25 V at 100 mA max
• Signals: Quadrature A and B with index I
• Logic: Differential receivers (can connect single ended)
• Maximum Rate: 100,000 lines/sec = 400,000 counts/sec
Pin assignments are as follows:
P IN S IGNAL
1 TEDS data
2 A+
3 A-
4 +5 V
5 I+
6 I-
7 Analog GND
8 B+
9 B-
10 TEDS ground
Criterion_product manual.book Page 72 Monday, July 28, 2014 3:52 PM