Purge and fill the pressure intensifier, Purge and fill the pressure intensifier 20 – MTS Model 286-31 Transient Permeability Pore Pressure Intensifier User Manual
Page 20
Advertising
286.31 Transient Permeability Pore Pressure Intensifier
20
Purging and Filling the Fluid Lines
Operation
Purge and Fill the Pressure Intensifier
1. Switch on electrical power at the control console.
2. Set up the test controller to control the 286.31’s Pressure Intensifier from the
Manual Control on the RCS (Remote Station Controller).
3. Select the pore pressure control channel’s most sensitive operating range.
4. Select pore pressure as the active control mode.
5. Apply high hydraulic pressure to the 286.31.
Advertising