MTS Multipurpose Elite Test - Manual (Page 25)

• Adjust commands settings (such as ramp and taper times). This is done using the Channel Options tool
in the Station Manager application.
• Access the values of calculation parameters and variables. This is done using the Calculation Editor in
the Station Manager applicationr.
• Set limit levels and actions for detectors.
• Position the actuator to install the specimen.
• Apply offsets.
MTS Station Manager Window
Station activities you can perform with the Multipurpose application
You can perform some station activities with the Multipurpose application, such as:
• Energize and de-energize actuator power.
• Reset and override interlocks.
• Start, hold, and stop tests.
• Perform Park, Unload, and Stop At operations.
Other station activities you may perform with Station Manager
You can perform some station activities pre-test or between tests, such as:
• Check shunt calibration levels
• Adjust tuning values
You can only perform these activities with the Station Manager application.
Multipurpose Elite Test Design Guide 25
3.0 Designing a Test