MTS Multipurpose Elite Test - Manual (Page 99)

If the event that caused the detector to trip is within the detector limits, the detectors and any action
assigned to that detector will be reset and returned to the normal (untripped) state.
If the event that caused the detector to trip is still true, the detector will trip and any action assigned to that
detector will occur again.
For more information on station limits, see Access and Set Detector Settings on page 98.
For more information on using the Station Manager application, see MTS Series 793 Control Software
(PN 100-147-130).
For More Information
Access and Set Detector Settings on page 98
7.3.0 Use Manual Command to Install the
Specimen
Positioning the actuator to install or remove a specimen must be performed using the Station Manager
application. The following procedures describe how to use the Manual Command window to position an
actuator.
An optional Model 494.05 Handset can be used with the Station Manager application to provide local, manual
control of the actuator.
For more information on using the Station Manager application, see the MTS Series 793 Control Software
manual (PN 100-147-130).
7.3.1.0 Manual Command Overview
This window provides manual control of channels. Use these controls to position the actuator during specimen
installation.
Access
Station Controls panel toolbar > Manual Command button
Multipurpose Elite Test Design Guide 99
7.0 MTS Controller Software