RKI Instruments SDM-2009 PC Controlled Configuration User Manual
Page 102
97 • Instrument Function Menu
NOTE:
The following parameters are instrument parameters, not PC Controller
Program parameters, and with the exception of Calibration Interval do
not affect the operation of the PC Controller Program. Since the PC
Controller Program uses the Calibration Interval setting retrieved from
the instrument to determine if a calibration is due, changing this setting
will affect the program’s operation.
Several instrument parameters are always selectable and do not depend on which
sub tab is selected.
•
Serial No.: To change the current instrument serial number, place the cursor in
the Serial No. field and enter the desired serial number. If you change the serial
number, once you upload the changes to the instrument and return to the main
program window, the PC Controller Program will indicate that the instrument
with the old serial number was disconnected. An instrument with the new serial
number will then connect to the PC Controller Program.
•
Station ID: To change the station ID, place the cursor in the Station ID field and
enter the desired station ID.
Figure 75: Parameter Tab, Instrument Without Bump Test Function