RKI Instruments SDM-2009 PC Controlled Configuration - Manual (Page 32)

27 • Setting Up the PC Controller Program
PC Controller Program” on page 23.
NOTE: It is not necessary to turn on the SDM-2009 docking stations if you are
only performing configuration setup.
2. The configuration parameters are located in the Configuration Window of the
SDM-GX Docking Station PC Controller program. To access the Configuration
Window, click the Config button along the top of the main program window.
3. You will be prompted to enter a password. The factory set password is
ABCDE. Enter the password and click OK keeping in mind that the password
is case sensitive. You may change the password using the Password Tab once
you have entered the Configuration Window. See “Password Tab” on page 107
for instructions to change the password.
4. The Parameter Tab of the Configuration Window will be displayed.
Figure 21: Config Window Parameter Tab