Rockwell Automation PF700 PowerFlex 700 Drive Components Replacement - Frame 9 - Manual (Page 23)

Rockwell Automation Publication 20B-IN025B-EN-P - January 2011 23
Basic Component Removal Procedures Chapter 2
9. Disconnect wire harnesses from TB11 to:
• J4 on the Switch Mode Power Supply Board
• TB1 and TB2 on the Power Interface Board
10. Label and remove all customer wiring from TB11.
11. Carefully set aside the Main Control Panel.
Install Components
1. When instructed for the component you are replacing, reinstall the Main
Control Panel Assembly components in the reverse order of removal.
2. Torque panel mounting screws to 2.9 N•m (26 lb•in).
3. Replace all safety shields and enclosure covers before applying power to the
drive.