Rockwell Automation 22-WIM-N1 DSI Wireless Interface Module - Manual (Page 17)

Chapter
2
Installing the WIM
Chapter 2 provides instructions for installing and removing the WIM.
The WIM is offered in two styles: a NEMA 1 module (22-WIM-N1) and
a NEMA 4 module (22-WIM-N4S). Each style is installed differently.
The NEMA 1 WIM (22-WIM-N1) is installed in a HIM bezel
(22-HIM-B1) that is mounted in a remote location.
1. If the HIM bezel is not mounted, refer to the HIM Bezel Installation
Instructions Publication No. 22HIM-IN002… for mounting details.
2. Route the bezel cable to the drive. Connect the bezel cable to the DSI
port on the bottom of the drive.
3. Install the WIM into the HIM bezel cradle ( Figure 2.1 ).
Figure 2.1 Installing the WIM in a HIM Bezel
Topic Page
Installing the NEMA 1 WIM (22-WIM-N1) 2-1
Installing the NEMA 4 WIM (22-WIM-N4S) 2-2
Removing the NEMA 1 WIM (22-WIM-N1) 2-4
Installing the NEMA 1 WIM (22-WIM-N1)
22-WIM-N1
(Wireless Interface Module)
22-HIM-B1
Bezel
PowerFlex 4/40/400 Drive
with Installed HIM
2 m (6.6 ft.)
Bezel Cable
Contains FCC ID: SNT-2XWIMNX IC: 5450A-2XWIMNX This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation