To reset a pin number when misplaced or forgotten, Resetting the wim, Resetting the wim -26 – Rockwell Automation 22-WIM-N1 DSI Wireless Interface Module User Manual
Page 46
3-26
Configuring the WIM
To reset a PIN number when misplaced or forgotten
If you misplaced or forget the assigned PIN number, you will not be able
to connect to the WIM using drive software. To reset the PIN number,
you will need to access the WIM through a different DSI peripheral (for
example, 22-HIM). Using that peripheral, select Parameter 05 -
[Security Mode] and set it to “0” (PIN Not Required). Then select
Parameter 06 - [Security PIN] to view the stored PIN number.
When using the WIM in RTU Master mode, DSI peripherals are not
supported. In this case, call Drives Technical Support for assistance. (See
for contact information.)
Changes to some WIM parameters require that you reset the WIM before
the new settings take effect. You can reset the WIM by cycling power to
the drive or by using Parameter 08 - [Reset Module].
Set Parameter 08 - [Reset Module] to Reset Module.
After you enter 1 = Reset Module, the WIM will be immediately reset.
Important: This will break the wireless connection, so you will need to
re-establish the connection.
When you enter 2 = Set Defaults, the WIM will set all WIM parameters
to their factory-default settings. After performing a Set Defaults, enter
1 = Reset Module so that the new values take effect. The value of this
parameter will be restored to 0 = Ready after performing the reset or
setting the defaults.
Resetting the WIM
Value Description
0
Ready (Default)
1
Reset Module
2
Set Defaults