Rockwell Automation 22-WIM-N1 DSI Wireless Interface Module - Manual (Page 19)

Installing the WIM 2-3
Figure 2.3 Hole Pattern for Mounting NEMA 4 WIM
2. Peel the protective film from the gasketed surface on the back of the
WIM ( Figure 2.4 ).
3. Insert the supplied 2 m (6.6 ft.) WIM cable into the mating socket on
the back of the WIM.
4. Install the supplied O-ring into the cable routing hole on the panel to
protect the cable. Then route the WIM cable through the cable
routing hole on the panel.
5. Align the six threaded studs of the WIM with the panel clearance
holes, and place the WIM against the panel.
6. Tighten the nuts onto the six threaded studs of the WIM extending
behind the panel. Recommended torque is 0.68 N-m (6.0 lb.-in.).
7. Route the WIM cable to the drive. Connect the WIM cable to the DSI
port on the bottom of the drive.
8. Apply power to the drive. The status LED on the WIM momentarily
flashes red on powerup and then flashes green to indicate it is ready
to establish wireless communication with the Pocket PC or computer.
67,0
(2.63)
60,0
(2.36)
77,0
(3.03)
77,0
(3.03)
53,5
(2.11)
∅19,1
(0.75)
∅4,8
(0.19)