Rockwell Automation 22-WIM-N1 DSI Wireless Interface Module - Manual (Page 84)

D-10 Using RTU Master Mode
5. Click Next -> to display the Connection Summary screen
( Figure D.15 ) which shows information about this drive being
connected to the network. Then click Save and Connect Now to
display the “Location for saved connection” screen (
Figure D.16 ).
6. Use the default name shown or enter a desired name (for this
example, Drive 1). Use the default directory shown or select a
different path to which the connection is saved on the Pocket PC.
Then click OK. The StatusMonitor screen for the drive appears.
7. Repeat Steps 1 through 6 for each remaining drive on the network.
8. After connections for all drives on the network have been created and
saved, you can now select any drive to access its information. With
any drive StatusMonitor screen (
Figure D.17 ) displayed, select
Connect > and then the desired drive file name (for this example,
Drive 2.dfc) to display its StatusMonitor screen (
Figure D.18 ). Then
select Tasks > Parameter (Linear) to access its parameter list.
Figure D.15 Connection Summary
Screen
Figure D.16 “Location for saved
connection” Screen
Figure D.17 Drive Selection
Screen
Figure D.18 Drive 2 StatusMonitor
Screen