Rockwell Automation 22-WIM-N1 DSI Wireless Interface Module - Manual (Page 62)

C-4 Wireless Flash Updating DSI Peripherals
5. Establish wireless communication between the WIM and Pocket PC.
For this procedure, refer to Using Pocket DriveExplorer for Pocket
PC on page 3-2 .
6. With the StatusMonitor screen ( Figure C.5 ) for the drive displayed,
select Port > and then the appropriate port number (for this example,
Port 1) to display the StatusMonitor screen (
Figure C.6 ) for the
peripheral device being flashed (for this example, the 22-COMM-D).
7. Select Tasks > Flash Update to open the DeviceFlash screen
( Figure C.7 ). In the Available Updates list, select the appropriate
firmware version (for this example, 1.007.01 Full). Then tap Next ->
to continue. The DeviceFlash update warning screen (
Figure C.8 )
appears.
Figure C.5 Port Selection Screen
Figure C.6 StatusMonitor Screen for
22-COMM-D
Figure C.7 DeviceFlash Screen
Figure C.8 DeviceFlash Update
Warning Screen