Rockwell Automation MV SMC Flex OEM Components - Manual (Page 36)

5-4 Control Component Installation
1503E-IN001E-EN-P – June 2013
Use the wire harness provided to connect the Voltage Sensing Board
and the Interface Board. Refer to Figure 5.2 for the location of the
connector on the interface board, and Figure 4.8 for the connector on
the voltage sensing board.
1) Use the fiber optic cables (Cat. No. 1503E-XXFOXX) to connect
each fiber optic receiver from the gate driver boards to the
interface board (refer to Figure 5.2). Ensure that the gate driver
boards of each power phase are connected to the correct terminals
on the Interface Board. Observe the minimum bend radius of at
least 45 mm (1.75 in.) for the fiber optic cables.
A T T E N T I O N A T T E N T I O N Do not sharply bend or strike the fiber optic
cables when handling them. A minimum bend
radius of at least 45 mm (1.75 in.) should be
maintained throughout the system. Damaging
the cables may result in signal loss to the
components and improper functioning of the
unit.
Fiber optic components are color coded for
easier connections. Receiver terminals are dark
blue, and transmitter terminals are grey or black.
The cables have a grey connector at one end and
a blue one at the other. When connecting to the
gate driver boards, the dark blue connector must
plug into the dark blue receiver and the grey
connector must plug into the black transmitter
Refer to the appropriate wiring diagram in Chapter 7.
It is acceptable to connect the fiber optic
transmitter cables to any port within a particular
power phase. Note that the cables for the
temperature feedback ports should be connected
to the correct phase. Refer to Figure 5.2 for the
Interface Board layout.
2) Connect the temperature feedback fiber optic receivers for each
phase to the appropriate gate driver board. Refer to Chapter 7 for
the appropriate diagram for the temperature feedback fiber optic
connections.
Connecting Interface Board
to Voltage Sensing Board
Connecting Interface Board
to Gate Driver Board
I M P O R T A N T I M P O R T A N T
I M P O R T A N T I M P O R T A N T