Rockwell Automation MV SMC Flex OEM Components - Manual (Page 55)

Appendix
B
1503E-IN001E-EN-P – June 2013
Typical MV SMC Flex Schematic Diagrams
Introduction
This Appendix contains a typical schematic for a complete MV SMC
Flex controller (refer to Figure B.1).
Refer to publication 1560E-UM051_-EN-P for additional samples of
MV SMC Flex wiring configuration. The examples shown are not a
recommendation for the correct wiring configurations, nor is the OEM
required to design the SMC Flex exactly as shown.
The OEM must ensure that all wiring for the SMC Flex unit meets all
performance and safety requirements, including any applicable laws,
regulations, codes and standards.
Rockwell Automation does not assume any responsibility or liability
for loss or damages caused by failures in the unit manufactured by the
OEM.
For more information, see the Warranty section in General Terms and
Conditions of Sale, Publication 6500-CO001_-EN-P.