Rockwell Automation MV SMC Flex OEM Components - Manual (Page 43)

Chapter
7
1503E-IN001E-EN-P – June 2013
Typical Wiring Diagrams
Wiring Diagrams
The following wiring diagrams illustrate the connections between the
main components of the MV SMC Flex OEM kits. Some of the
connections are pre-made by Rockwell Automation, depending on the
type of OEM kit being used. It is the responsibility of the OEM to
correctly identify the OEM kit utilized and the connections they must
make.
Additional components are typically required to complete the MV
SMC. Refer to Appendix B for examples of how these additional
components can be implemented to form a complete solution.
A T T E N T I O N A T T E N T I O N Wires used for connecting the components must
be sufficiently insulated to withstand system
voltage. Refer to the appropriate wiring diagram
for the wire insulation requirements. Failure to
use adequately insulated wiring may cause
injury to personnel and/or damage to the
equipment.