Rockwell Automation MV SMC Flex OEM Components - Manual (Page 7)

Chapter
2
1503E-IN001E-EN-P – June 2013
Receiving and General Information
Receiving
Refer to Getting Started, General Handling Procedures for Medium
Voltage Controllers - Publication MVB-5.0. This document is
included with your shipment and contains information regarding
receiving, unpacking, initial inspection, handling, storage, and site
preparation.
A T T E N T I O N A T T E N T I O N Printed circuit boards contain components that
can be damaged by electrostatic charges that
build up on personnel during normal activities.
Exercise the following precautions when
handling electrostatic sensitive devices. Failure
to do so may damage the device and render it
inoperable.
To guard against electrostatic damage (ESD) to equipment, the
following precautions should be observed when handling electrostatic
sensitive devices.
1) Use a grounding wrist strap to minimize the build up of static
charges on personnel.
2) Handle the module by the edges and avoid touching components or
printed circuit paths.
3) Store devices with sensitive components in the conductive
packaging that the module is shipped in.
These precautions are the minimum requirements for guarding against
ESD. For more information refer to Guarding Against Electrostatic
Damage - Publication ICCG-4.3. See the Additional Publications
section for information on obtaining this document.
Handling Procedures for
Electrostatic Sensitive
Devices