Use rslinx software to create a routing table, Introduction, Choose the correct software – Rockwell Automation 1756-DH485 ControlLogix DH-485 Communication Module User Manual User Manual
Page 47: Chapter 4, Introduction -1 choose the correct software -1, In chapter 4, Chapter

1
Publication 1756-UM532A-EN-P - May 2006
Chapter
4
Use RSLinx Software to Create a Routing
Table
Introduction
This chapter describes how to configure your 1756-DH485 module in
DH-485 applications. For more information on the configuration software,
refer to the online help in each.
Choose the Correct
Software
The programming software you need is dependent on what products you are
using with the 1756-DH485 module. The table below explains what software is
needed for your application.
For
See
Use RSLinx Software to Create a Routing
Table
Software Needed for 1756-DH485 Applications
If you are using this product with the
1756-DH485 module to read/write data
in a DH-485 application
You must use this software
SLC Controllers
RSLinx, version 2.43 or later
RSLogix 500, version 6.3 or later
ControlLogix Controllers
RSLinx, version 2.43 or later
RSLogix 5000