Hardware configuration, Hardware configuration -2 – Rockwell Automation 1756-DH485 ControlLogix DH-485 Communication Module User Manual User Manual
Page 86
Publication 1756-UM532A-EN-P - May 2006
9-2 Communicate to a SLC 5/03 Controller on a DH-485 Network
Hardware Configuration
In this hardware configuration, the ControlLogix controller initiates a CIP
message from the 1756-DHRIO module to an SLC 5/03 controller located on
a DH-485 network.
DH+/RIO
DH485
DH+/RIO
ControlLogix
Controller
1756-DHRIO
(2)
1756-DH485
(3)
Channel A
(4)
The SLC 5/03 controller
receives the message.
(6)
DH-485 network
communicates
through link
couplers.
(5)
44066
1756-DHRIO
(1)
DH+ Network
AIC+
AIC
• The communication path goes from the local
1756-DHRIO module across the DH+ network to
another 1756-DHRIO module on the same DH+
network. (1)
• The remote 1756-DHRIO module is node 12 octal or
10 decimal. (2)
• This 1756-DHRIO module at node 12 is located on the
same backplane as a 1756-DH485 module in slot 14. (3)
• Channel A (4) of the 1756-DH485 module is on a
DH-485 network (5) with an SLC 5/03 controller as
node 1. (6)
ControlLogix
Controller