Rockwell Automation 1756-DH485 ControlLogix DH-485 Communication Module User Manual - Manual (Page 93)

Publication 1756-UM532A-EN-P - May 2006
Communicate from a Logix Controller to an SLC 5/03 Controller over EtherNet/IP and DH-485 Networks 10-5
This is the Communication tab for the remote message.
Path Item Description
series_A This means go to the
backplane to slot 5 where
the 1756-ENBT named
Series_A is located.
Series A is defined as
backplane 1, slot 5.
2 EtherNet/IP port.
100.100.100.7 The remote 1756-ENBT.
1 Go to the backplane of the
remote 1756 chassis.
14 Go to the slot location of
the 1756-DH485 module.
2 Go out Channel A of the
1756-DH485 module.
1 Go to Node 1 or the
location of the SLC 5/03
controller.
TIP
You do not need to create a routing
table when your communication
method is CIP messaging.