Rockwell Automation 1771-TCM,D17716.5.108 TEMPERATURE CONTROL MOD - Manual (Page 16)

Installing the Module
Chapter 2
2-4
When installing your module in an I/O chassis:
1. Turn off power to the I/O chassis:
ATTENTION: Remove power from the 1771 I/O chassis
backplane and disconnect the cable from the module before
removing or installing an I/O module.
Failure to remove power from the backplane could cause injury
or equipment damage due to possible unexpected operation.
Failure to remove power from the backplane could cause
module damage, degradation of performance, or injury.
2. Place the module in the plastic tracks on the top and bottom of the
slot that guides the module into position.
3. Do not force the module into its backplane connector. Apply firm
even pressure on the module to seat it properly.
4. Snap the chassis latch over the top of the module to secure it.
For the temperature control module, you must use the 1771-RTP1 Remote
termination panel. The remote termination panels are designed for
mounting on standard DIN 1 or DIN 3 mounting rails. Mounting
dimension are shown in Figure 2.2.
Figure 2.2
Mounting Dimensions for the 1771ĆRTP1 Remote Termination Panels
135
(5.30)
75
(3.0)
1771ĆRTP1
59
(2.3)
Millimeters
(Inches)
J1
J2
J3
J4
J8
J7
J6
J5
A B
Installing the Module
Installing the Remote
Terminator Panel