Rockwell Automation 1771-TCM,D17716.5.108 TEMPERATURE CONTROL MOD - Manual (Page 66)

Monitoring Status Data
Chapter 7
7-16
Word Description Bits
23 0 LoopĆ8 Enable
• 0 = Loop 8 disabled.
• 1 = Loop 8 enabled.
1 LoopĆ8 Auto/Manual Mode Select Ċ (controlled by bit 1 of word 30 of the dynamic block)
• 0 = Loop 8 is in the manual mode Ċ the manual output value (from word 33, dynamic block) is used as the CV value.
• 1 = Loop 8 is in the automatic mode Ċ the PID algorithm generates the CV value.
2 LoopĆ8 Open Circuit
• 0 = LoopĆ8 thermocouple circuit is closed (connection OK).
• 1 = .LoopĆ8 thermocouple circuit is open (connection broken).
3 LoopĆ8 Parameters valid
• 0 = Power has been interrupted since valid parameters for loop 8 have been blockĆtransferred.
• 1 = Valid parameters for loop 8 have been blockĆtransferred since last loss of power .
4 LoopĆ8 Calibration Fault
• 0 = LoopĆ8 calibration is OK.
• 1 = LoopĆ8 cannot operate with as calibrated.
5 LoopĆ8 SetĆPoint Select Ċ (controlled by bit 2 of word 30 of the dynamic block)
• 0 = Select the standbyĆtemperature setĆpoint value from word 31 of the dynamic block.
• 1 = Select the runĆtemperature setĆpoint value from word 32 of the dynamic block.
6 LoopĆ8 Parameter Value Error
• 0 = LoopĆ8 parameter values OK.
• 1 = LoopĆ8 parameter value error.
7 LoopĆ8 AutoĆTuning Complete
• 0 = LoopĆ8 autoĆtuning is not complete.
• 1 = LoopĆ8 autoĆtuning is complete.
8 Reserved.
9 Reserved.
10 LoopĆ8 Thermal Runaway Ċ (set in words 22 and 23 of the configuration block)
• 0 = LoopĆ8 is operating within thermal runaway limit..
• 1 = LoopĆ8 has exceeded the thermal runaway limit. and the CV value has been forced..
11 LoopĆ8 High CV Limit Ċ (set in word 7 of the configuration block)
• 0 = LoopĆ8 CV value is below the high CV limit.
• 1 = LoopĆ8 CV value is at the high CV limit.
12 LoopĆ8 Low CV Limit Ċ (set in word 8 of the configuration block)
• 0 = LoopĆ8 CV value is above the low CV limit.
• 1 = LoopĆ8 CV value is at the low CV limit.