Rockwell Automation 1788-EN2DNR EtherNet/IP to DeviceNet Linking Device User Manual - Manual (Page 18)

18 Rockwell Automation Publication 1788-UM059A-EN-P - August 2014
Chapter 2 Install the Linking Device
6. In the Network Configuration dialog box, enter the following values.
7. Click Apply Changes.
8. Follow the on-dialog box prompts.
9. Cycle power to the linking device.
Configure the Driver in
RSLinx Software
1. In RSLinx software, choose Communications > Configure Drivers.
2. From the Available Driver Types pull-down menu, choose EtherNet/IP
Driver.
3. Click Add New.
4. In the Add New RSLinx Drivers dialog box, click OK.
5. In the Configure Driver window, select the EtherNet/IP network
interface, and click OK.
6. Click Close.
Register the EDS File The EDS file for the linking device is accessible and downloadable with RSLinx.
To register the EDS file in RSLinx software, follow these steps.
1. In RSLinx software, right-click the linking device.
2. Select Upload EDS File from Device.
3. Click Next or Finish for the remaining dialog boxes.
Description Type
IP Address Any valid value. See your system administrator for a
valid IP address.
Subnet Mask Any valid value.
Default Gateway
Primary Name Server
Secondary Name Server
Default Domain Name
Host Name