3 - configure the linking device, Rsnetworx for devicenet software, Chapter 3 – Rockwell Automation 1788-EN2DNR EtherNet/IP to DeviceNet Linking Device User Manual User Manual
Page 19: Configure the linking device, Chapter
Advertising
Rockwell Automation Publication 1788-UM059A-EN-P - August 2014
19
Chapter
3
Configure the Linking Device
RSNetWorx for DeviceNet
Software
1. In RSNetWorx for DeviceNet software, choose Network > Online.
2. In the left pane, click the RSLinx Ethernet driver you added previously.
Configure the Driver in RSLinx Software on page 18
.
3. In the left pane, click the + next to the 1788-EN2DNR linking device
icon.
4. In the left pane, choose DeviceNet, DeviceNet.
5. When asked to upload from the network, click OK to perform a single
pass browse.
Advertising