2 - install the linking device, System requirements, Required hardware – Rockwell Automation 1788-EN2DNR EtherNet/IP to DeviceNet Linking Device User Manual User Manual
Page 9: Required software, Chapter 2, Install the linking device, Required hardware required software, Chapter
Rockwell Automation Publication 1788-UM059A-EN-P - August 2014
9
Chapter
2
Install the Linking Device
System Requirements
The following hardware and software components are required to use the linking
device.
Required Hardware
• 1788-EN2DNR linking device
• Two 121 Ω (1%, 1/4 watt) termination resistors (shipped with the linking
device)
• DeviceNet cabling, power, and devices forming a DeviceNet network
• Ethernet cabling
• Computer with USB connection or access to the Ethernet network
• 24 V DC power to the linking device
DeviceNet power can be used; however, using DeviceNet power bypasses
the DeviceNet network isolation.
Required Software
• RSNetWorx for DeviceNet software, version 21 or later, to configure
DeviceNet devices and the linking device’s DeviceNet functionality
• RSLinx®
software, version 3.51 or later
• RSLogix 5000 version 20 or Studio 5000 Automation Engineering &
Design Environment™, version 21 or later.