Rockwell Automation 1788-EN2DNR EtherNet/IP to DeviceNet Linking Device User Manual - Manual (Page 34)

34 Rockwell Automation Publication 1788-UM059A-EN-P - August 2014
Chapter 4 USB Cable
Configure the USB Driver
To configure RSLinx software to use a USB port, you need to configure a USB
driver.
To configure a USB driver, perform this procedure.
1. Connect the linking device and your workstation by using a USB cable.
The Found New Hardware Wizard appears.
2. Click any of the Windows Update connections options and click Next.
3. Click Install the software automatically (Recommended) and click Next.
The software is installed.
TIP If the software for the USB driver is not found and the installation is
cancelled, verify that you have installed RSLinx Classic software,
version 2.57 or later.