Rockwell Automation 7000 PowerFlex Medium Voltage Air-Cooled (B Frame) Installation - ForGe Control - Manual (Page 65)

Rockwell Automation Publication 7000-IN007E-EN-P - June 2014 65
Chapter
4
Pre-Commissioning Responsibilities
Rockwell Automation manages the start-up service for each installed drive at the
customer’s site, but there are a number of tasks you must complete before you
schedule RA personnel for drive commissioning.
This chapter outlines the required pre-commissioning responsibilities. Review
this information prior to commissioning the drive as a reference for drive line-up
commissioning. Record the information in the data sheets provided; these are
useful during future maintenance and troubleshooting exercises.
Perform the pre-commissioning tasks in the order listed in this chapter. Failure to
do so may result in equipment failure or personal injury.
Inspection and Verification Before the drive commissioning occurs, Rockwell Automation recommends the
following:
1. Arranging a pre-installation meeting with Rockwell Automation
personnel to review:
a. the start-up plan
b. the start-up schedule
c. the drive(s) installation requirements
2. Inspecting the drive’s mechanical and electrical devices.
3. Performing a tug test on all internal connections within the drive and
verify wiring.
4. Verifying critical mechanical connections for proper torque requirements.
5. Verifying and adjusting mechanical interlocks for permanent location.
6. Confirming all inter-sectional wiring connections.
7. Re-verifying control wiring from any external control devices, such as
PLCs, etc.
8. Confirming cooling system is operational.
IMPORTANT Rockwell Automation requests a minimum of four weeks’ notice to schedule
each start-up.
The standard Rockwell Automation work hours are between 9:00 AM to
5:00 PM EST, (8 hr/day) Monday through Friday, not including observed
holidays. Additional working hours are available on a time and material basis.