Rockwell Automation 2708-DH5B2L_DH5B4L Attended Workstation - Manual (Page 182)

Index
Index–2
Menu 4, 5-8
Menu 5, 5-10
Menu 6, 5-10
Network Menu Parameters, 5-4
Workstation, 5-4
Workstation Type, 5-4
Alternate, 5-4
Alternate Submaster, 5-4
Concentrator, 5-4
Gateway, 5-4
Host Port, 5-4
Lower Poll Addr (1-100) -, 5-4
Master, 5-4
Max Net Retries (1-99) -, 5-5
Normal, 5-4
Offline Cycle (normally 40) -, 5-5
Submaster, 5-4
Upper Poll Addr (1-99) -, 5-5
Read Only Menu, 5-10
System Menu Parameters, 5-8
Clock Mode, 5-8
Current date, 5-8
Current time, 5-8
File Block Size, 5-8
Menu Password, 5-8
Using Menus from the Comm Port, 5-3
Using Menus via Workstation Keypad,
5-1
Exiting Network Menu, 5-2
Sub-Menus, 5-2
D
Developing and Running an A-B BASIC
Program, 10-1
A-B BASIC Run-Time Errors, 10-5
Format of a BASIC Error Message,
10-5
Loading and Auto-Starting an A-B
BASIC Program, 10-3
Power Failure, 10-6
Start-up Condition of an A-B BASIC
Program, 10-3
LCD, 10-3
Termination of an A-B BASIC Program,
10-4
The A-B BASIC Development
Procedure, 10-1
Coding with QuickBASIC Editor, 10-1
Coding with the Workstation
Application Generator Software,
10-1
Compiling the A-B BASIC Program,
10-2
Downloading, 10-2
Simulation Using Application Library,
10-1
Differences Between A-B BASIC and
QuickBASIC, L-1
Distance Limitations, E-1
RS-232 Cable Length, E-1
RS-485 Cable Length, E-1
DO...LOOP, L-10
E
Error Messages and Prompts, H-1
Errors, Warnings, and Status Messages,
H-1
H
Host Communications, 8-1
Network Directives, 8-4
Abort Currently Running A-B BASIC
Program, 8-7
Abort Test, 8-7
Display Text on Front Panel, 8-7
Initialize Network, 8-8
Menu Password, 8-8
Reboot Unit, 8-8
Reset to Factory Defaults, 8-8
Restart an Aborted BASIC Program,
8-7
Send Text Out Aux Comm Port, 8-7
Send Text Out Comm Port, 8-7
Set Time, 8-9
Show Firmware Version, 8-6
Show Last Error Message, 8-5
Show Last Reset Message, 8-5
Show Unit Display, 8-5
Show Unit Serial Number, 8-6
Show Workstation Date & Time, 8-6
Zero Reset Error, 8-9