Rockwell Automation 2708-DH5B2L_DH5B4L Attended Workstation - Manual (Page 47)

Chapter 5
Configuration Menus
5–6
Polled The workstation transmits only when polled. However, if
DSR or Polled mode are selected, XON/XOFF will also be
honored by the workstation.
Request This mode does error checking and retransmission of all data
blocks. It is intended for electrically noisy environments.
Comm Baud Rate
The following baud rates are available:
19200 1200
9600 600
4800 300
2400 150
75
Comm Data Bits
The parameters are 7 to 8.
Comm Parity
Your choice of parities for 7 data bits are:
Even
Odd
None
Zero
Mark
Your choice of parities for 8 data bits are:
Even
Odd
None
Comm Stop Bits – Parameters available are:
One
Two
One and a half
Comm CRLF Parameters are Enabled or Disabled. When enabled, the
workstation will send a line-feed after each carriage
return that it transmits.
Comm Echo The choices are Enabled or Disabled. When enabled, the
workstation will echo each character it receives from the
comm line back to the communications line. This must
be disabled when communicating with most Host
computers.
Sync Count When 0, asynchronous communication is enabled on the
COM1 port. This should always be left at 0 (zero).