Rockwell Automation 2708-DH5B2L_DH5B4L Attended Workstation - Manual (Page 43)

Chapter 5
Configuration Menus
5–2
Sub-Menus
After you have selected the appropriate menu item, you can now examine the
sub-menu by pressing <ENTER>.
With the exception of the Diagnostic Menu (which is discussed later), you
can scan through the list of parameters by pressing <ENTER>, and scan
backwards by pressing <CLEAR>. The parameter which appears on the
display is the one which is selected.
Once a parameter is selected, it may be changed. The settings or options
suitable for that parameter can be examined/changed by pressing
<LEFT ARROW>. For some parameters, this is a numeric item which
requires that you enter a value in order to modify it. Once the parameter
has been changed, you must press <ENTER> for the parameter to be
accepted. If you press <EXIT> or <CLEAR> without having pressed
<ENTER>, you selection will be ignored.
Note: Once you have entered the diagnostics menu (by pressing <ENTER>
from the 6-Diagnostics menu) use <LEFT ARROW> to move through and
select the diagnostic you want to execute. Press <ENTER> to start the
diagnostic. Most diagnostics can be stopped by pressing <EXIT>. Pressing
<EXIT> from any of the parameters will return the unit to the Network Menu
(Figure 5.1).
Exiting Network Menu
Pressing <EXIT> from the Network Menu will exit the menus completely.
First, “Final Exit” (Figure 5.2) will briefly appear on the display, to be
replaced either by the status display, or in the case where a program has been
already placed into the workstation, program run will begin.
Figure 5.2
Final Exit Menu
Final Exit.
Using Menus via
Workstation Keypad (cont’d)