Rockwell Automation 2708-DH5B2L_DH5B4L Attended Workstation - Manual (Page 63)

Chapter 5
Configuration Menus
5–22
F–Lamp Test
If this test is selected, it will turn on, one by one, each of the keypad LEDs.
After all the lights are on, the workstation will return to the G–Lamp Test
Menu and the LEDs will return to off.
G–Reset Powerup
When the Reset Powerup Test is entered, it reboots the workstation, causing
the workstation to go through the entire power-up sequence exactly as if
power had been removed, then re-applied.
H–Reset Unit to Factory Defaults
When <ENTER> is pressed while Reset Unit to Factory Defaults is on the
display, it causes all of the workstation parameters, those described in the
Network, Comm and Bar Code menus, to be reset to the way they were set
when the workstation left the factory. This is particularly helpful when
attempting to track other problems, as the factory defaults are a known
starting place from which to work. Refer to Chapter 6 for default values.
Menu 6: Diagnostics
Menu Parameters (cont’d)