Rockwell Automation 2708-DH5B2L_DH5B4L Attended Workstation - Manual (Page 51)

Chapter 5
Configuration Menus
5–10
The Read Only Menu displays the following information:
1–ROM configuration, version and date
2–RAM side
3–Serial Number
4–Program Load Status – i.e. never loaded or never started
The diagnostics provided in the firmware of the workstation allow testing of
the internal hardware, as well as many devices which may be attached to the
workstation.
The following are specific diagnostic tests with the identifier for each:
1–Kbd/Laser Test
2–Display Test
3–Dest. RAM Test
4–Cont. RAM Test
5–Comm Tx Test
6–Comm Rx Test
7–Comm Loop Test
8–Aux TX Test
9–Aux Rx Test
A–Aux Loop Test
B–RS485 Blk Rx (Block Receive)
C–RS485 Blk Tx (Block Transmit)
D–RS232 Blk Rx (Block Receive)
E–RS232 Blk Tx (Block Transmit)
F–Lamp Test
G–Reset Powerup
H–Reset Unit to Factory Defaults
* –Internal Use Only
Use the <IN>: key to scan forward and the <OUT> key to scan backwards,
or use the number/letter of the test to select it directly. Press <ENTER> to
start the test. <EXIT> stops most tests.
Menu 5: Read Only Menu
Menu 6: Diagnostics
Menu Parameters