Rockwell Automation 2708-DH5B2L_DH5B4L Attended Workstation - Manual (Page 50)

Chapter 5
Configuration Menus
5–9
Code 3 of 9 Mode
ASCII
Full ASCII character set. . . . . . . . . . . . . .
Normal Only Does not allow +$ to switch mode. . . . . . . . .
ASCII Only Does not allow -$ to switch mode. . . . . . . . . .
Code I 2-of -5 Disabled/Enabled . . . . . . .
Used to enable Interleaved 2 of 5.
I 2-of-5 Check Dgts Enabled/Disabled . .
I 2-of-5 Length
This command enables and disables the I 2-of-5 label length checking. There
are three types of label length checking:
n = 0
I 2-of-5 symbols can be of any (even) length between 4 and 32 digits,
inclusive.
n > = 3 and n < = 32
Only symbols of length n will be read. If an odd value of ‘n’ is specified, it
will be incremented to the next even integer since I 2-of-5 symbols must
have an even number of digits.
n = 33
Then the symbols can be either 6 or 14 digits long.
Codabar Disabled/Enabled . . . . . . . . . . .
Used to enable Codabar.
Code 128 Disabled/Enabled . . . . . . . . . .
Used to enable Code 128.
UPC UPC/EAN/JAN, UPC only, or Disabled . . . . . . . . . . . . . .
Used to enable UPC, European and Japanese Codes.
UPC Supplement None, 2-digit only, 5-digit only, or 2 and 5 . . .
Enables reading of the 2 or 5 digit supplement to the standard UPC code.
Bar Header None or STX . . . . . . . .
This selects a header to be sent in front of bar codes which are SENT IN
STANDALONE MODE ONLY. By default, no header is sent.
Bar Trailer CR, NONE, ETX, or TAB . . . . . . . . .
This selects a trailer to be placed on the end of barcodes which are sent in
STANDALONE MODE ONLY. By default a carriage return is sent.
Bar Echo Enabled/Disabled . . . . . . . . . .
This enables the echo of bar codes to the display in STANDALONE MODE
ONLY.
Menu 4: Bar Code
Menu Parameters (cont’d)